Supported Juniper Networks Vsas - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Table 39: AAA Accounting Message RADIUS IETF Attributes Supported
(continued)
Attribute
Number Attribute Name
[96] Framed-Interface-Id
(See Note 1.)
[97] Framed-Ipv6-Prefix
(See Note 5.)
[99] Framed-IPv6-Route
[100] Framed-IPv6-Pool
[123] Delegated-Ipv6-Prefix
[188] Ascend-Num-In-Multilink
(See Note 3.)

Supported Juniper Networks VSAs

Copyright © 2010, Juniper Networks, Inc.
Acct-Start
Table 40 on page 182 lists the Juniper Networks (Vendor ID 4874) VSAs supported for
Acct-Start, Acct-Stop, Interim-Acct, Acct-On, Acct-Off, Partition-Accounting-On, and
Partition-Accounting-Off messages.
The following notes are referred to in Table 40 on page 182:
The attribute is not included in Acct-Stop messages that are sent when a user session
1.
does not get established in one of the following situations.
The aaa accounting acct-stop on-access-deny command is enabled and the
authentication server sends an Access-Reject (deny) message.
The aaa accounting acct-stop on-aaa-failure command is enabled and the
authentication server issues an Access-Accept message (grant), but the AAA
configuration denies access for the user. The aaa accounting acct-stop
on-aaa-failure is enabled by default.
The aaa accounting acct-stop on-aaa-failure command is enabled and the user
terminates before AAA receives the authentication response from the authentication
server.
ERX routers send IPv6 accounting attributes in the Acct-Stop and Interim-Acct
2.
messages (stop, interim) when they are configured to return these attributes and
when the subscriber is either an IPv6 subscriber or a combined IPv4/IPv6 subscriber
in a dual stack. For an IPv4 subscriber, IPv6 accounting attributes are not included in
the accounting messages even if the IPv6 accounting is enabled.
In JunosE Release 10.1.x and lower-numbered releases, the combined accounting
statistics were retrieved at the layer 2. Therefore, error or discarded packets in the
layer 2 itself were excluded in these statistics. Because the layer 2 cannot detect the
Chapter 3: Configuring RADIUS Attributes
Acct-Stop Interim-Acct Acct-On Acct-Off
– –
– –
– –
– –
– –
– –
181