Radius Client Terminate Reasons; Table 56: Default Radius Client Mappings - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

RADIUS Client Terminate Reasons

Copyright © 2010, Juniper Networks, Inc.
Table 55: Default PPP Mappings (continued)
PPP Terminate Reason
osi link down
osi max configure exceeded
osi no local align npdu
osi no peer align npdu
osi no service
osi peer renegotiate rx conf ack
osi peer renegotiate rx conf nak
osi peer renegotiate rx conf rej
osi peer renegotiate rx conf req
osi peer terminate code rej
osi peer terminate term ack
osi peer terminate term req
osi service disable
osi stale stacking
Table 56 on page 301 lists the default RADIUS client terminate mappings. The table
indicates the supported RADIUS client terminate reasons and the RADIUS
Acct-Terminate-Cause attributes they are mapped to by default.

Table 56: Default RADIUS Client Mappings

RADIUS Client Terminate Reason
no-acct-server
system-reboot
virtual-router-deletion
Chapter 7: Application Terminate Reasons
RADIUS Acct-Terminate-Cause
Code Description
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
RADIUS Acct-Terminate-Cause
Code Description
10 nas request
10 nas request
10 nas request
301