Table 104: Show Atm Subinterface Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Meaning
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
host1#show atm subinterface atm 2/0.100
Interface ATM-Prot VCD VPI VCI
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 2/0.100 ATM/MPLS 100
Maximum number of cells per packet: 100
Cell aggregation timeout timer:
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Table 104 on page 571 lists the show atm subinterface command output fields; for a
description of the other fields in this display, see Monitoring ATM in the JunosE Link Layer
Configuration Guide.

Table 104: show atm subinterface Output Fields

Field Name
Encap
Maximum number of cells
per packet
Cell aggregation timeout
timer
NOTE: For ATM over MPLS interfaces, the ATM-Prot field displays
ATM/MPLS.
show atm subinterface
Chapter 10: Monitoring Layer 2 Services over MPLS
Circuit
Type Encap MTU
0 100 PVC AAL0 9180 lowerLayerDown Static
2
0
0
0
0
0
0
0
0
Field Description
Encapsulation type:
AAL0—VCC cell relay–encapsulated circuits that receive raw
ATM cells
AAL5—ATM cross-connect interfaces
Maximum number of ATM cells that the router can concatenate in
a single packet; if this value is not configured, " Martini cell
aggregation: disabled" appears instead of this field. Displayed for
an individual ATM over MPLS interface with AAL0 encapsulation
Identifier (1, 2, or 3) of the ATM Martini cell packing timer that detects
timeout of the cell collection threshold; if this value is not configured,
" Martini cell aggregation: disabled" appears instead of this field.
Displayed for an individual ATM over MPLS interface with AAL0
encapsulation
Interface
Status Type
571