Overview - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
Service Interim Accounting for IPv4 and IPv6 Services in a Dual Stack Overview
668
Use to specify the default interval between user accounting updates. The router uses
the default interval when no value is specified in the RADIUS Acct-Interim-Interval
attribute (RADIUS attribute 85).
This command and the aaa service accounting interval command replace the aaa
accounting interval command, which is deprecated and might be removed in a future
release.
The default interval is applied on a virtual router basis—this setting is used for all users
who attach to the corresponding virtual router.
Specify the user accounting interval, in the range 10–1440 minutes. The default setting
is 0, which disables the feature.
Example
host1(config)#aaa user accounting interval 20
Use the no version to reset the accounting interval to 0, which turns off interim user
accounting when no value is specified in the RADIUS Acct-Interim-Interval attribute.
See aaa user accounting interval
You can query the external parent group statistics similar to the statistics retrieved for
classifier lists. You must specify the correct external parent group name and its
corresponding hierarchical policy parameter for each of the input, output, and
secondary-input statistics. You can specify a list of external parent groups along with
hierarchical policy parameter for which statistics must be collected and sent to Service
Manager for display in the Acct-Stop and Interim-Acct messages. The statistics for
packets arriving at an interface attached at the input stage and the statistics for packets
arriving at an interface attached at the secondary input stage are added and displayed
in the Input Bytes field of the show service-management command. The statistics for
packets leaving an interface at which the hierarchical policy is defined are displayed in
the Output Bytes field of the show service-management command. The external parent
group statistics are not limited to combined IPv4 and IPv6 services in a dual stack. You
can also obtain external parent group statistics for IPv4 and IPv6 services configured
independently in a dual stack.
You can retrieve either external parent group statistics or classifier statistics from policy
manager. However, you cannot retrieve both the statistics for a single service definition.
When a combined service is configured, you cannot retrieve classifier list-based based
statistics. In such a scenario, you can only retrieve external parent group-based statistics
from policy manager.
Service interim accounting and accounting based on service deactivation are supported
for IPv6 services. For the combined IPv4 and IPv6 service, the statistics are a sum of the
values in the external parent group and hierarchical policy parameter pair lists (defined
as input-stat-epg, secondary-input-stat-epg, and output-stat-epg in the service definition
macro).
Copyright © 2010, Juniper Networks, Inc.