Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 76

JunosE 11.3.x Broadband Access Configuration Guide
radius trap auth-server-not-responding
radius trap auth-server-responding
radius trap no-acct-server-responding
radius trap no-auth-server-responding
38
Use to enable or disable SNMP traps when a RADIUS accounting server returns to
service after being marked as unavailable.
The associated SNMP object is rsRadiusClientTrapOnAcctServerAvailable.
This command affects only the current VR context.
Example
host1(config)#radius trap acct-server-responding enable
Use the no version to restore the default, disable.
See radius trap acct-server-responding
Use to enable or disable SNMP traps when a RADIUS authentication server fails to
respond to a RADIUS Access-Request message.
The associated SNMP object is rsRadiusClientTrapOnAuthServerUnavailable.
Example
host1(config)#radius trap auth-server-not-responding enable
Use the no version to return to the default setting, disabled.
See radius trap auth-server-not-responding
Use to enable RADIUS to send SNMP traps when a RADIUS authentication server
returns to service after being marked as unavailable.
The associated SNMP object is rsRadiusClientTrapOnAuthServerAvailable.
This command affects only the current VR context.
Example
host1(config)#radius trap auth-server-responding enable
Use the no version to restore the default setting, disabled.
See radius trap auth-server-responding
Use to enable or disable SNMP traps when all of the configured RADIUS accounting
servers per VR fail to respond to a RADIUS accounting request.
The associated SNMP object is rsRadiusClientTrapOnNoAcctServerAvailable.
Example
host1(config)#radius trap no-acct-server-responding enable
Use the no version to return to the default setting, disabled.
See radius trap no-acct-server-responding
Copyright © 2010, Juniper Networks, Inc.