radius include framed-ip-netmask
radius ignore framed-ip-netmask
radius include framed-compression
Copyright © 2010, Juniper Networks, Inc.
Example
host1(config)#radius include framed-ip-addr acct-start enable
Use the no version to restore the default, enable.
[9] Framed-Ip-Netmask
Use the following commands to manage the Framed-IP-Netmask RADIUS attribute.
radius include framed-ip-netmask
radius ignore framed-ip-netmask
Use to include the Framed-Ip-Netmask attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include framed-ip-netmask acct-start enable
Use the no version to restore the default, enable.
Use to cause the Framed-Ip-Netmask attribute to be ignored in Access-Accept
messages.
You can control this behavior by enabling or disabling this command.
If the subnet mask is specified by the Frame-Ip-Netmask attribute in the RADIUS user
profile, the router passes the mask and IP address to the CPE during IPCP negotiations.
When this command is enabled, the default subnet mask 255.255.255.255 is provided
by AAA and used for IPCP negotiations.
Enabling the command guards against any breaks in the negotiation.
See radius ignore
Example
host1(config)#radius ignore framed-ip-netmask disable
Use the no version to restore the default, enable.
[13] Framed-Compression
Use the following command to manage the Framed-Compression RADIUS attribute.
radius include framed-compression
Use to include the Framed-Compression attribute in Acct-Start or Acct-Stop messages.
Chapter 3: Configuring RADIUS Attributes
193