Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 551

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
relayVr:fastEthernet 1/2:4
bostonHost:fastEthernet 1/2.3:4
Ethernet interface with Stacked VLAN
[<hostname>|<vrname>:]<interface type> <slot>/<port>[.<sub-if>]:
<svlan id>-<vlan id>
Examples:
fastEthernet 1/2.3:4-5
relayVr:fastEthernet 1/2:4-5
bostonHost:fastEthernet 1/2.3:4-5
LAG interface
[<hostname>|<vrname>:]<interface type> <bundle name>
Examples:
lag bundleA
relayVr:lag bundleA
bostonHost:lag bundleA
LAG interface with VLAN
[<hostname>|<vrname>:]<interface type> <bundle name>[.<sub-if>]:<vlan id>
Examples:
lag bundleA.1:2
relayVr:lag bundleA:2
bostonHost:lag bundleA.1:2
LAG interface with Stacked VLAN
[<hostname>|<vrname>:]<interface type> <bundle name>[.<sub-if>]:
<svlan id>-<vlan id>
Examples:
lag bundleA.1:2-3
relayVr:lag bundleA:2-3
bostonHost:lag bundleA.1:2-3
The remote-id-only keyword specifies the Agent Remote ID suboption, which contains
a value only when (1) the interface is a dynamic ATM interface and (2) the subscriber
command is used to configure a username and domain name for the interface. If both
conditions are met, the suboption contains a string with the username and domain name
in the format: username@domainname. The remote-id-only keyword disables support
for the Agent Circuit ID suboption.
If you do not explicitly specify the circuit-id-only or remote-id-only keyword, both
suboptions are used.
radius remote-circuit-id-format
set dhcp relay
set dhcp relay agent
Chapter 20: Configuring DHCP Relay
513