Using Aaa Default Tunnel Parameters To Configure The Transmit Connect Speed Calculation Method - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Using AAA Default Tunnel Parameters to Configure the Transmit Connect Speed Calculation
Method
Copyright © 2010, Juniper Networks, Inc.
Tunnel
Tunnel Failover
Tag Resync
------ --------
3 <null>
You can configure the transmit connect speed calculation method as a default AAA
tunnel parameter by using the aaa tunnel tx-connect-speed-method command from
Global Configuration mode. This command applies the specified calculation method to
all tunneled L2TP sessions associated with a particular virtual router, and thereby
alleviates the need for you to configure the transmit connect speed calculation method
for each individual subscriber.
Configuring the calculation method as a default AAA tunnel parameter for a virtual router
has lower precedence than using AAA domain maps, AAA tunnel groups, or RADIUS to
configure the transmit connect speed calculation method. The router uses the calculation
method specified with the aaa tunnel tx-connect-speed-method command if the tunnel
attributes returned from an AAA domain map, an AAA tunnel group, or a RADIUS
authentication server do not include the transmit connect speed calculation method.
To configure the transmit connect speed calculation method for all tunneled L2TP
sessions associated with a particular virtual router:
Create the virtual router for which you want to configure the transmit connect speed
1.
calculation method.
host1(config)#virtual-router north
For more information about configuring and using virtual routers, see the Configuring
Virtual Routers chapter in JunosE System Basics Configuration Guide.
Configure the transmit connect speed calculation method in the context of this virtual
2.
router.
host1:north(config)#aaa tunnel tx-connect-speed-method qos
To specify the calculation method for the transmit connect speed, use one of the
following keywords, as described in "Using AAA Tunnel Groups to Configure the
Transmit Connect Speed Calculation Method" on page 402:
static-layer2
dynamic-layer2
qos
actual
(Optional) Use the show aaa tunnel-parameters command to verify configuration
3.
of the transmit connect speed calculation method.
Tunnel
Tunnel Tx
Switch Speed
Profile Method
------- ------
<null> qos
Chapter 13: Configuring an L2TP LNS
403