Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 62

Software for e series broadband services routers broadband access configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
Table of Contents

Advertisement

JunosE 11.3.x Broadband Access Configuration Guide
aaa accounting broadcast
24
host1(config-radius)#timeout 5
(Optional) Specify the maximum number of outstanding requests.
6.
host1(config-radius)#max-sessions 100
(Optional) Specify the amount of time to remove a server from the available list when
7.
a timeout occurs.
host1(config-radius)#deadtime 10
(Optional) In Global Configuration mode, specify whether the E Series router should
8.
move on to the next RADIUS server when the router receives an Access-Reject message
for the user it is authenticating.
host1(config)#radius rollover-on-reject enable
(Optional) Enable duplicate address checking.
9.
host1(config)aaa duplicate-address-check enable
(Optional) Specify that duplicate accounting records be sent to the accounting server
10.
for a virtual router.
host1(config)#aaa accounting duplication routerBoston
(Optional) Enter the correct virtual router context, and specify the virtual router group
11.
to which broadcast accounting records are sent.
host1(config)#virtual-router vrSouth25
host1:vrSouth25(config)#aaa accounting broadcast westVrGroup38
host1:vrSouth25(config)#exit
(Optional) Specify that immediate accounting updates be sent to the accounting
12.
server when a response is received to an Acct-Start message.
host1(config)#aaa accounting immediate-update
(Optional) Specify whether the router collects all statistics or only the uptime status.
13.
host1(config)#aaa accounting time
(Optional) Specify that tunnel accounting be enabled or disabled.
14.
host1(config)#radius tunnel-accounting enable
(Optional) Specify the default authentication and accounting methods for the
15.
subscribers.
host1(config)#aaa authentication ppp default radius none
(Optional) Disable UDP checksums on virtual routers you configure for B-RAS.
16.
host1:(config)#virtual router boston
host1:boston(config)#radius udp-checksum disable
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents