Configuration Example - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Software for e series broadband services routers broadband access configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
Table of Contents

Advertisement

Configuration Example

Copyright © 2010, Juniper Networks, Inc.
Table 8: Supported RADIUS Acct-Terminate-Cause Codes (continued)
Code
Name
12
Port Unneeded
13
Port Preempted
14
Port Suspended
15
Service Unavailable
16
Callback
17
User Error
18
Host Request
19
Supplicant Restart
20
Reauthentication
Failure
21
Port Reinitialized
22
Port Administratively
Disabled
This example describes a sample configuration procedure that creates custom mappings
for PPP terminate reasons.
Configure the router to include the Acct-Terminate-Cause attribute in RADIUS Acct-Off
1.
messages.
host1(config)#radius include acct-terminate-cause acct-off enable
(Optional) Display the current PPP terminate-cause mappings.
2.
host1(config)# run show terminate-code ppp
Apps
Terminate Reason
--------- --------------------------
ppp
authenticate-authenticator
-timeout
ppp
authenticate-challenge-tim
eout
ppp
authenticate-chap-no-resou
rces
Chapter 1: Configuring Remote Access
Description
NAS ended the session because the resource usage fell below
the low threshold; for example, the bandwidth-on-demand
algorithm determined that the port was no longer needed
NAS ended the session to allocate the port to a higher-priority
use
NAS ended the session to suspend a virtual session
NAS was unable to provide the requested service
NAS is terminating the current session in order to perform callback
for a new session
An error in the user input caused the session to be terminated
The login host terminated the session normally
Supplicant state machine was reinitialized
A previously authenticated supplicant failed to reauthenticate
successfully following expiration of the reauthentication timer or
explicit reauthentication request by management action
The port's MAC has been reinitialized
The port has been administratively disabled
Description
-------------------------- ------
authenticate authenticator
timeout
authenticate challenge tim
eout
authenticate chap no resou
rces
Radius
Code
17
10
10
83

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents