Table 40: Aaa Accounting Message Juniper Network (Vendor Id 4874) Vsas; Supported - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Software for e series broadband services routers broadband access configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
Table of Contents

Advertisement

JunosE 11.3.x Broadband Access Configuration Guide
3.
Table 40: AAA Accounting Message Juniper Network (Vendor ID 4874) VSAs Supported
Attribute
Number
Attribute Name
[26-10]
Ingress-Policy-Name
[26-11]
Egress-Policy-Name
[26-24]
Pppoe-Description
(See Note 1.)
[26-42]
Acct-Input-Gigapackets
[26-43]
Acct-Output-Gigapackets
[26-44]
Tunnel-Interface-Id
[26-45]
Ipv6-Virtual-Router
[26-46]
Ipv6-Local-Interface
[26-47]
Ipv6-Primary-DNS
[26-48]
Ipv6-Secondary-DNS
[26-51]
Disconnect-Cause
182
error or discarded packets in the layer 3, the combined statistics also include the error
or discarded packets of the layer 3. In this release, with the support for RADIUS VSAs
for IPv6 accounting, the IPv6 statistics are retrieved at the layer 3. To be consistent
with the combined statistics, the error or discarded packets of the layer 3 are also
included in these IPv6 statistics.
The ICR partition accounting messages comprise the following:
Partition-Accounting-On—Sent to the RADIUS server whenever an ICR partition
changes to the master state from the backup state. The Partition-Accounting-On
message has the same Acct-Status-Type attribute value as the Accounting-On
message, but also contains the ICR-Partition-Id VSA, which specifies the ICR partition
to which this message corresponds.
Partition-Accounting-Off—Sent to the RADIUS server when the partition changes
from the master state to the backup state. However, in the event of a complete
chassis failure, the Partition-Accounting-Off message is not sent.
Partition-Accounting-Off message has the same Acct-Status-Type attribute value
as the Accounting-Off message and contains the ICR-Partition-Id VSA to denote
the ICR partition to which the message is associated.
For more information about how to configure and use ICR partitions, see the Managing
Interchassis Redundancy chapter in the JunosE Services Availability Configuration Guide.
Acct-Start
Acct-Stop
Interim-Acct
Acct-On
Acct-Off
Copyright © 2010, Juniper Networks, Inc.
Partition-
Partition-
A c c o u n t i n g - O n
A c c ounti n g-Off

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents