Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 750

Software for e series broadband services routers broadband access configuration guide
Hide thumbs Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
Table of Contents

Advertisement

JunosE 11.3.x Broadband Access Configuration Guide
712
Table 160: show ipv6 interface Output Fields (continued)
Field Name
Multicast Packets, Bytes
In Total Dropped Packets, Bytes
In Policed Packets
In Invalid Source Address Packets
In Error Packets
In Discarded Packets
Out Forwarded Packets, Bytes
Unicast Packets, Bytes
Multicast Routed Packets, Bytes
Out Total Dropped Packets, Bytes
Out Scheduler Dropped Packets,
Bytes
Out Policed Packets
Out Discarded Packets
IPv6 policy
rate-limit-profile
Field Description
Multicast packets and bytes received on the IP
interface which are then multicast-routed are counted
as multicast packets.
Total number of packets and bytes that were dropped
on the interface
Packets discarded on a receive IP interface for any of
the following reasons: exceeding the token bucket
limit, exceeding the rate limit, a drop action in a policy,
discarded MAC validation packets, a destination
address lookup failure or when the destination
address is an IP interface that has a route configured
to the null interface.
Packets discarded on a receive IP interface because
of invalid IP source address
Packets discarded on a receive IP interface because
of IP header errors
Packets discarded on the ingress interface because
of a configuration problem rather than a problem with
the packet itself
Total number of packets and bytes forwarded out of
the IP interface
Unicast packets and bytes forwarded out of the IP
interface
Multicast packets and bytes forwarded out of the IP
interface
Total number of packets and bytes that were
discarded on the egress interface
Number of outbound packets and bytes dropped by
the scheduler
Packets discarded on the egress interface because
of rate limiting
Packets discarded on the egress interface because
of a configuration problem rather than a problem with
the packet itself
Type (input, output, local-input) and name of policy
Name of profile
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents