Setting The Baseline For Radius Dynamic-Request Server Statistics; Monitoring Radius Dynamic-Request Server Statistics - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
Related
Documentation

Setting the Baseline for RADIUS Dynamic-Request Server Statistics

Related
Documentation

Monitoring RADIUS Dynamic-Request Server Statistics

Purpose
Action
Meaning
310
attribute ingress-policy-name (vsa) accepted from RADIUS server
attribute virtual-router (vsa) accepted from RADIUS server
attribute pppoe-max-session (vsa) ignored from RADIUS server
show radius attributes-ignored
You can set a statistics baseline for packet mirroring-related RADIUS statistics. To show
baseline statistics, use the delta keyword with the show radius dynamic-request
statistics command.
To set a baseline for RADIUS statistics for packet mirroring:
Issue the baseline radius dynamic-request command:
host1#baseline radius dynamic-request
There is no no version.
Monitoring RADIUS Dynamic-Request Server Statistics on page 310
baseline radius dynamic-request
Display RADIUS dynamic-request server statistics.
To display RADIUS dynamic-request statistics:
host1#show radius dynamic-request statistics
RADIUS Request Statistics
-------------------------
Statistic
-----------------------------
UDP Port
Disconnect Requests
Disconnect Accepts
Disconnect Rejects
Disconnect No Session ID
Disconnect Bad Authenticators
Disconnect Packets Dropped
CoA Requests
CoA Accepts
CoA Rejects
CoA No Session ID
CoA Bad Authenticators
CoA Packets Dropped
No Secret
Unknown Request
Invalid Addresses Received
Table 59 on page 311 lists the show radius dynamic-request statistics command output
fields.
10.10.3.4
-------
1700
0
0
0
0
0
0
0
0
0
0
0
0
0
0
:0
Copyright © 2010, Juniper Networks, Inc.