Removing Qos Configurations Referenced By Service Manager; Figure 30: Qos Configuration Dependency Chain - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Removing QoS Configurations Referenced by Service Manager

Copyright © 2010, Juniper Networks, Inc.
Conversely, QoS profiles and parameter instances configured through RADIUS can be
overwritten by any source (SNMP, the SRC software, CLI, and Service Manager).
SNMP, the SRC Software, and the CLI
QoS profile attachments and parameter instances configured through the CLI can
overwrite QoS profile attachments and parameter instances configured through any
source.
QoS profiles attached through SNMP and the SRC software can also overwrite QoS
profile attachments configured through any source.
Conversely, QoS profiles and parameter instances configured through the CLI, SNMP, or
the SRC software can be overwritten by any source.
When Service Manager no longer references a QoS configuration, it must be removed
from the service definition.
Figure 30 on page 649 shows the references for QoS configurations.

Figure 30: QoS Configuration Dependency Chain

Service Manager automatically removes QoS profiles and parameter instances. After
removing the QoS profile and parameter instances, Service Manager automatically
removes the following QoS configurations in the following order:
QoS profiles
1.
Scheduler profiles
2.
Queue profiles
3.
Drop profiles
4.
Statistics profiles
5.
Service Manager does not automatically remove the following QoS configurations:
Chapter 27: Configuring Service Manager
649