Application Terminate Reasons; Aaa Terminate Reasons; Table 53: Default Aaa Mappings - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

CHAPTER 7

Application Terminate Reasons

AAA Terminate Reasons

Copyright © 2010, Juniper Networks, Inc.
This chapter lists the default mappings for application terminate reasons to RADIUS
Acct-Terminate-Cause attributes. Table 53 on page 277 lists the default mappings for
AAA, Table 54 on page 278 lists default mappings for L2TP, Table 55 on page 295 lists the
default mappings for PPP, and Table 56 on page 301 lists default mappings for RADIUS
client. See "Mapping Application Terminate Reasons to RADIUS Terminate Codes" on
page 82 in "Configuring Remote Access" on page 3 for information about configuring
custom mappings for application terminate reasons to RADIUS Acct-Terminate-Cause
attributes.
AAA Terminate Reasons on page 277
L2TP Terminate Reasons on page 278
PPP Terminate Reasons on page 294
RADIUS Client Terminate Reasons on page 301
Table 53 on page 277 lists the default AAA terminate mappings. The table indicates the
supported AAA terminate and deny reasons and the RADIUS Acct-Terminate-Cause
attributes they are mapped to by default.

Table 53: Default AAA Mappings

AAA Shutdown or Deny Reason
deny address allocation failure
deny address assignment failure
deny application error
deny authentication denied
deny authentication failure
deny authorization failure
RADIUS Acct-Terminate-Cause
Code Description
17 user error
17 user error
17 user error
17 user error
17 user error
17 user error
277