Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 66

JunosE 11.3.x Broadband Access Configuration Guide
aaa duplicate-address-check
aaa user accounting interval
28
NOTE: IP subscriber management interfaces are static or dynamic
interfaces that are created or managed by the JunosE Software's
subscriber management feature.
Specify one of the following types of accounting methods:
radius—RADIUS authentication for the specified subscribers.
none—Grants the specified subscribers access without authentication.
radius none—Multiple types of authentication; used in the order specified. For
example, radius none specifies that RADIUS authentication is initially used; however,
if RADIUS servers are not available, users are granted access without authentication.
Example
host1(config)#aaa authentication ip default radius
Use the no version to set the authentication protocol to the default, radius.
See aaa authentication default
Use to enable or disable routing table address lookup or duplicate address check.
By default, this command is enabled.
The router checks the routing table for returned addresses for PPP users. If the address
existed, then the user was denied access.
You can disable this routing table address lookup or duplicate address check with the
aaa duplicate-address-check command.
Example
host1(config)#aaa duplicate-address-check enable
There is no no version.
See aaa duplicate-address-check
Use to specify the default interval between user accounting updates. The router uses
the default interval when no value is specified in the RADIUS Acct-Interim-Interval
attribute (RADIUS attribute 85).
This command and the aaa service accounting interval command replace the aaa
accounting interval command, which is deprecated and might be removed in a future
release. For information about setting the default interim accounting interval for services,
see "Configuring Service Manager" on page 633.
The default interval is applied on a virtual router basis—this setting is used for all users
who attach to the corresponding virtual router.
Copyright © 2010, Juniper Networks, Inc.