Monitoring Tunnel Subscriber Authentication - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Related
Documentation

Monitoring Tunnel Subscriber Authentication

Purpose
Action
Meaning
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Table 13: show aaa domain-map Output Fields (continued)
Field Name
Tunnel Client Name
Tunnel Server Name
Tunnel Preference
Tunnel Max Sessions
Tunnel RWS
Tunnel Virtual Router
Tunnel Failover Resync
Tunnel Switch Profile
Tunnel Tx Speed Method
show aaa domain-map
Verify configuration of tunnel subscriber authentication. When authentication is enabled,
the output indicates this configuration. When authentication is disabled, the output
presents no information about the configuration.
To display tunnel subscriber authentication configuration:
host1#show aaa domain-map
Domain: tunnel.com; auth-router-name: default; ip-router-name: default
ipv6-router-name: default; tunnel-subscriber authentication: enable
Authentication is enabled.
show aaa domain-map
Chapter 2: Monitoring and Troubleshooting Remote Access
Field Description
Host name that the LAC sends to the LNS when
communicating to the LNS about the tunnel
Host name expected from the peer (the LNS) when
during tunnel startup
Preference level for the tunnel
Maximum number of sessions allowed on a tunnel
L2TP receive window size (RWS) for a tunnel on the
LAC; displays either the configured value or the default
behavior, which is indicated by system chooses
Name of the virtual router to map to the user domain
name
L2TP peer resynchronization method
Name of the L2TP tunnel switch profile
Method that the router uses to calculate the transmit
connect speed of the subscriber's access interface:
static layer2, dynamic layer2, qos, actual, not set
119