Table 89: Show L2Tp Session Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
Meaning
Related
Documentation
440
Statistics packets octets discards errors
Data rx 7 237
Data tx 6 160
Session operational configuration
User name is 't1.s1@local'
Tunneling PPP interface atm 0/0.1
Call type is lacIncoming
Call serial number is 0
Bearer type is none
Framing type is none
Proxy LCP was provided
Authentication method was chap
Tunnel switch profile is chicago
Table 89 on page 440 lists the show l2tp session command output fields.

Table 89: show l2tp session Output Fields

Field Name
Configuration
Administrative state
SNMP traps
Session status
Effective administrative state
State
Local and peer session id
Statistics
Session operational configuration
show l2tp session
1 0
0 0
Field Description
Configured status of the session
Administrative status of the destination:
enabled—No restrictions on the operation of this
session
disabled—Router terminated this session
Whether or not the router sends traps to Simple
Network Management Protocol (SNMP) for
operational state changes
Session status of the destination
Most restrictive of the following administrative states:
router, destination, tunnel, and session. This setting,
rather than the administrative state of the session,
determines whether the router can maintain this
session or not.
Status of the session: idle, connecting, established,
or disconnecting
Names the router uses to identify the session locally
and remotely
Information about the traffic for this session
Information received from the peer when the session
was created
Copyright © 2010, Juniper Networks, Inc.