Supported Radius Ietf Attributes; Table 37: Aaa Access Message Radius Ietf Attributes Supported - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide

Supported RADIUS IETF Attributes

Table 37: AAA Access Message RADIUS IETF Attributes Supported

Attribute
Number Attribute Name
[1] User-Name
[2] User-Password
[3] CHAP-Password
[4] NAS-IP-Address
[5] NAS-Port
[6] Service-Type
[7] Framed-Protocol
[8] Framed-IP-Address
[9] Framed-IP-Netmask
[11] Filter-Id
[12] Framed-MTU
(See Note 2.)
[18] Reply-Message
(See Note 2.)
[22] Framed-Route
[24] State
(See Note 2.)
170
Table 37 on page 170 lists the Access-Request, Access-Accept, Access-Reject,
Access-Challenge, CoA, and Disconnect-Request attributes supported by JunosE
Software. The following notes are referenced in Table 37 on page 170:
Attribute is used by Access-Request messages when terminating a PPP connection
1.
at the LNS or the initiating LAC.
Attribute is used to support pass-through exchange of EAP messages.
2.
Attribute is used by Access-Challenge messages to set the PPP retransmission timeout
3.
used for EAP request packets.
Table 37 on page 170 lists the RADIUS IETF attributes supported for Access-Request,
Access-Accept, Access-Reject, CoA-Request, and Disconnect-Request messages.
Access- Access-
Request Accept
–
–
–
–
–
–
–
–
– –
Access- Access- CoA-
Reject Challenge Request
– –
– – –
– – –
– – –
– – –
– – –
– – –
– –
– – –
– – –
– – –
–
– – –
–
Copyright © 2010, Juniper Networks, Inc.
Disconnect-
Request
–
–
–
–
–
–
–
–
–
–
–
–
–