Monitoring Service Manager; Setting A Baseline For Http Local Server Statistics - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

CHAPTER 28

Monitoring Service Manager

Setting a Baseline for HTTP Local Server Statistics

Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to monitor the Service Manager application. This chapter
discusses the following topics:
Setting a Baseline for HTTP Local Server Statistics on page 697
Monitoring the Connections to the HTTP Local Server on page 698
Monitoring the Configuration of the HTTP Local Server on page 698
Monitoring Statistics for Connections to the HTTP Local Server on page 699
Monitoring Profiles for the HTTP Local Server on page 700
Monitoring the Default Interval for Interim Accounting of Services on page 701
Monitoring the Status of the Service Manager License on page 701
Monitoring Profiles for Service Manager on page 702
Monitoring IPv4 and IPv6 Interfaces for Service Manager on page 703
Monitoring Service Definitions on page 713
Monitoring Service Session Profiles on page 714
Monitoring Active Owner Sessions with Service Manager on page 715
Monitoring Active Subscriber Sessions with Service Manager on page 718
Monitoring the Number of Active Subscriber and Service Sessions with
Service Manager on page 721
You can set a baseline for HTTP server statistics.
The system implements the baseline by reading and storing the statistics at the time the
baseline is set and then subtracting this baseline whenever baseline-relative statistics
are retrieved.
To set a baseline:
Include the baseline ip http command at the User Exec or Privilege Exec level:
host1#baseline ip http
There is no no version.
697