Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 109

aaa route-download
Copyright © 2010, Juniper Networks, Inc.
host1(config)#exit
host1#show aaa route-download
AAA Route Downloader:
Download Interval:
Retry Interval:
Default Cost:
Default Tag:
Base User Name:
Password:
Synchronization:
Status:
Last Download Attempt:
Last Download Success:
Last Regular Download:
Next Download Scheduled:
Next Regular Download:
Use to enable the RADIUS route-download server on the router and to configure
parameters for the server. You can configure the following parameters:
download interval—The amount of time the route-download server waits between
route download operations. The newly created server downloads routes as soon as
the IP protocol is active on the virtual router that performs the route download
operation, and then repeats the download operation every 720 minutes by default.
You can set a download interval in the range 1–1440 minutes.
retry-interval—The amount of time the server waits after a download failure before
attempting another route download. You can set the retry interval in the range 1–60
minutes. The default interval is 10 minutes.
NOTE: If the download interval is less than the retry interval, the server
ignores the retry interval setting.
cost—The cost of a downloaded route. You can specify a cost in the range 1–254.
The default cost is 2.
tag—The tag assigned to a downloaded route. You can specify a tag in the range
1–4294967295. The default tag is 0.
base-user-name—The virtual router that is used for route-download requests. The
default name is the router hostname.
Chapter 1: Configuring Remote Access
configured in virtual router default
1200 minutes
25 minutes
2
0
<HOSTNAME>
dl1456atl
03:45:00
downloading
TUE FEB 9 22:07:30 2007
<NEVER>
not complete
<DOWNLOAD ACTIVE>
WED FEB 9 22:27:00 2007
71