Monitoring Src Client Connection Status - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
Related
Documentation

Monitoring SRC Client Connection Status

Purpose
Action
Meaning
150
show aaa duplicate-prefix-check
Display the current status of the SRC client connection to the SAEs. The command output
refers to the SRC client by its former name, SSC client.
To display the status of the SRC client connection:
host1#show sscc info
The SSC Client configured protocols : IP(v4), DHCP(v4), L2TP(LAC)
The SSC Client is currently unconnected
The SSC Client configured servers are:
Primary: 10.10.2.2:3
Secondary: 0.0.0.0:0
Tertiary: 0.0.0.0:0
Local Source: FastEthernet 0/0, Local Source Address: 10.13.5.61
The configured transport router is: default
The configured retry timer is (seconds): 90
The configured update-policy-request is: Enabled
The connection state is: NoConnection
SSC Client Statistics:
Policy Commands received
Policy Commands(List)
Policy Commands(Acct)
Bad Policy Cmds received
Error Policy Cmds received 0
Policy Reports sent
Connection Open requests
Connection Open completed
Connection Closed sent
Connection Closed remotely 0
Create Interfaces sent
Delete Interfaces sent
Active IP Interfaces
IP Interface Transitions
Synchronizes received
Synchronize Complete sent
Internal Errors
Communication Errors
Tokens Seen
Active Tokens
Token Transitions
Token Creates Sent
Token Deletes Sent
Active Addresses
Address Transitions
Create Addresses Sent
Delete Addresses Sent
Authentication Successes
Authentication Failures
Table 30 on page 151 lists the show sscc info command output fields.
0
0
0
0
0
0
0
0
0
0
2
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Copyright © 2010, Juniper Networks, Inc.