Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 663

service dhcp-local
set dhcp relay giaddr-selects-interface
vlan id
Copyright © 2010, Juniper Networks, Inc.
Use the no version to remove the network address and mask.
See network
Use to enable the DHCP local server to operate in either equal-access mode or
standalone mode.
Example
host1(config)#service dhcp-local standalone
Use the no version to disable the DHCP local server.
See service dhcp-local
Use to configure DHCP relay to use information in the giaddr in DHCP server-destined
packets to identify the primary interface on which dynamic subscriber interfaces are
built. See "Using the Giaddr to Identify the Primary Interface for Dynamic Subscriber
Interfaces" on page 498 for additional information about this feature.
Example
host1(config)#set dhcp relay giaddr-selects-interface
Use the noversion to restore the default in which DHCP relay builds dynamic subscriber
interfaces on the IP interface that is used for DHCP server-destined messages.
See set dhcp relay giaddr-selects-interface
Use to configure a VLAN ID for a VLAN subinterface.
Specify a VLAN ID number that is in the range 0–4095 and is unique within the Ethernet
interface.
Issue the vlan id command before you configure any upper-layer interfaces, such as
IP.
Example
host1(config-if)#vlan id 400
There is no no version.
See vlan id
Chapter 25: Configuring Subscriber Interfaces
625