Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 317

Copyright © 2010, Juniper Networks, Inc.
Table 54: Default L2TP Mappings (continued)
L2TP Terminate Reason
session admin drain
session call down
session call failed
session create failed limit reached
session create failed no resources
session create failed single shot tunnel already fired
session create failed too busy
session failover protocol resync disconnect
session hardware unavailable
session no resources server port
session not ready
session rx cdn
session rx cdn avp bad hidden
session rx cdn avp bad value assigned session id
session rx cdn avp duplicate value assigned session id
session rx cdn avp malformed bad length
session rx cdn avp malformed truncated
session rx cdn avp missing mandatory assigned session id
session rx cdn avp missing mandatory result code
session rx cdn avp missing random vector
session rx cdn avp missing secret
session rx cdn avp unknown
session rx cdn no resources
Chapter 7: Application Terminate Reasons
RADIUS Acct-Terminate-Cause
Code Description
6 admin reset
10 nas request
15 service unavailable
9 nas error
9 nas error
9 nas error
9 nas error
6 admin reset
8 port error
9 nas error
9 nas error
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
279