Monitoring Radius Dynamic-Request Servers - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (750 pages)
Table of Contents
Advertisement
JunosE 11.3.x Broadband Access Configuration Guide
Monitoring RADIUS Dynamic-Request Servers
246
Use to specify the UDP port on which the RADIUS dynamic-request server listens to
receive messages from the RADIUS server.
Example
host1(config-radius)#udp-port 1770
Use the no version to return to the default, port 1700.
See udp-port
To monitor RADIUS dynamic-request servers, see:
"Setting the Baseline for RADIUS Dynamic-Request Server Statistics" on page 310
"Monitoring RADIUS Dynamic-Request Server Statistics" on page 310
"Monitoring the Configuration of the RADIUS Dynamic-Request Server" on page 311
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
