Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 290

JunosE 11.3.x Broadband Access Configuration Guide
key
radius relay server
radius relay udp-checksum
udp-port
252
------------- ---------------
10.10.1.0 255.255.255.0
192.168.102.5 255.255.255.255
Udp Port: 1813
Use to enter the IP address and mask of the network that will use the RADIUS relay
server, and to specify the key (secret) used during exchanges between the RADIUS
relay server and client.
Example
host1(config-radius-relay)#key 10.10.15.25 255.255.255.0 Secret3Clientkey
Use the no version to delete the secret.
See key
Use to configure a RADIUS relay authentication or accounting server and enter RADIUS
Relay Configuration mode.
Example
host1(config)#radius relay authentication server
host1(config-radius-relay)#
Use the no version to unconfigure the RADIUS relay server.
See radius relay server
Use to enable or disable UDP checksum for RADIUS relay packets.
Example
host1(config)#radius relay udp-checksum enable
Use the no version to restore the default, enable.
See radius relay udp-checksum
Use to specify the router's UDP port on which the RADIUS relay server resides.
Example
host1(config-radius-relay)#udp-port 1850
Use the no version to return to the default, port 1812 for authentication servers or port
1813 for accounting servers.
See udp-port
-------
NO8pxq
12BE$56
Copyright © 2010, Juniper Networks, Inc.