Table 7: Traffic-Shaping Vsas That Apply To Dynamic Ip Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

atm
Copyright © 2010, Juniper Networks, Inc.
7 on page 81 describes VSAs that apply to dynamic IP interfaces and are supported on
a per-user basis from RADIUS.

Table 7: Traffic-Shaping VSAs That Apply to Dynamic IP Interfaces

VSA Description
Service-Category Specifies the
type of service
PCR Specifies the
value for the
peak cell
rate (PCR)
SCR Specifies the
value for the
sustained cell
rate (SCR)
MBS Specifies the
maximum burst
size (MBS)
To configure traffic-shaping parameters for PPPoA via domain maps, use the atm
command in Domain Map Configuration mode.
Use to configure traffic-shaping parameters for PPPoA.
Use one of the following keywords to select the traffic category to configure:
ubr—Unspecified bit rate
ubrpcr—Unspecified bit rate with peak cell rate
nrtvbr—Non–real time variable bit rate
rtvbr—Real time variable bit rate
cbr—Constant bit rate
Example
host1(config)#aaa domain-map atmTraffic
host1(config-domain-map)#atm rtvbr 3897832145 3597861230 4294967295
Use the no version to remove the traffic-shaping configuration.
See atm
Chapter 1: Configuring Remote Access
Type Length Subtype
26 12 14
26 12 15
26 12 16
26 12 17
Subtype
Length Value
6 integer:
1 – UBR
2 – UBR PCR
3 – NRT VBR
4 – CBR
5 – RT VBR
6 integer
6 integer
6 integer
81