Setting Baselines For Remote Access - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (750 pages)
Table of Contents
Advertisement
JunosE 11.3.x Broadband Access Configuration Guide
Setting Baselines for Remote Access
112
Monitoring AAA Server Attributes on page 131
Monitoring the COPS Layer Over SRC Connection on page 133
Monitoring Statistics About the COPS Layer on page 135
Monitoring Local Address Pool Aliases on page 137
Monitoring Local Address Pools on page 138
Monitoring Local Address Pool Statistics on page 139
Monitoring Shared Local Address Pools on page 140
Monitoring the Routing Table on page 140
Monitoring the B-RAS License on page 141
Monitoring the RADIUS Server Algorithm on page 141
Monitoring RADIUS Override Settings on page 141
Monitoring the RADIUS Rollover Configuration on page 142
Monitoring RADIUS Server Information on page 142
Monitoring RADIUS Services Statistics on page 144
Monitoring RADIUS SNMP Traps on page 148
Monitoring RADIUS Accounting for L2TP Tunnels on page 148
Monitoring RADIUS UDP Checksums on page 148
Monitoring RADIUS Server IP Addresses on page 149
Monitoring Duplicate IPv6 Prefixes on page 149
Monitoring SRC Client Connection Status on page 150
Monitoring SRC Client Connection Statistics on page 152
Monitoring the SRC Client Version Number on page 154
Monitoring Subscriber Information on page 154
Monitoring Application Terminate Reason Mappings on page 159
You can set baseline statistics using the baseline commands. The router implements
the baseline by reading and storing the statistics at the time the baseline is set and then
subtracting this baseline when you retrieve baseline-relative statistics.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
