Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 578

JunosE 11.3.x Broadband Access Configuration Guide
Meaning
540
-------- -------- ----------
external 0.0.0.0 30
relay-p 0.0.0.0 2
To display count information for DHCP client bindings and interfaces with the specified
interface string:
host1:vr2#show dhcp count interface ip71.*4
Type IpSubnet Interfaces
-------- -------- ----------
external 0.0.0.0 3
This show dhcp count command uses the * (asterisk) regular expression metacharacter
in the interface string to display information for DHCP client bindings on virtual router
vr2 with an IP address beginning with 71 and ending with 4.
To display count information for DHCP client bindings and interfaces that match the
specified circuit ID string:
host1:vr3#show dhcp count circuit-id \\xe3
Type IpSubnet Interfaces
------- -------- ----------
relay-p 0.0.0.0 1
To specify nonprintable byte codes in the circuit ID string or remote ID string, you can use
the string \\xab, where ab is a hex code of the byte. This show dhcp count command
uses the string \\xe3 to represent byte E3 in the circuit ID string. This command displays
information for the DHCP client bindings on virtual router vr3 with the specified circuit ID
string, with results arranged in ascending order by binding ID.
To display count information for DHCP local server client bindings and interfaces with a
specified subnet address:
host1:vr1#show dhcp count local 0.0.0.0
To display count information for DHCP client bindings and interfaces with a specified IP
prefix:
host1:vr1#show dhcp count ip—prefix 71.1.0.0/28
To display count information for DHCP relay proxy client bindings without a lower-layer
interface:
host1:vr1#show dhcp count relay—proxy no-interface
To display count information for DHCP client bindings that match the specified remote
ID string:
host1:vr1#show dhcp count remote-id "remote id.*odd"
Filtering the display of DHCP client bindings by the circuit ID string or remote ID string is
not supported for the DHCP external server application. DHCP external server does not
store information about the agent-circuit-id suboption or agent-remote-id suboption of
option 82.
Table 105 on page 541 lists the show dhcp count command output fields.
------- -------- -------
30 30 30
30 30 30
Assigned Bound
Clients Clients Clients
------- -------- -------
3 3 3
Assigned Bound
Clients Clients Clients
------- -------- -------
15 15 15
Copyright © 2010, Juniper Networks, Inc.