Method; Table 72: Tunnel--Tx-Speed-Method Radius Attribute - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (750 pages)
Table of Contents
Advertisement
JunosE 11.3.x Broadband Access Configuration Guide
Using RADIUS to Configure the Transmit Connect Speed Calculation Method
Table 72: Tunnel--Tx-Speed-Method RADIUS Attribute
Attribute
Number
Attribute Name
[26-94]
Tunnel-Tx-Speed-Method
Related
Documentation
404
host1:north(config)#run show aaa tunnel-parameters
Tunnel password is <NULL>
Tunnel client-name is <NULL>
Tunnel nas-port-method is none
Tunnel switch-profile is boston
Tunnel tx-connect-speed-method is qos
Tunnel nas-port ignore disabled
Tunnel nas-port-type ignore disabled
Tunnel assignmentId format is assignmentId
Tunnel calling number format is fixed
On the LAC, the router can receive tunnel configuration attributes through a RADIUS
authentication server. To use RADIUS to configure the transmit connect speed calculation
method for a subscriber's access interface, you can configure RADIUS to include the
Tunnel-Tx-Speed-Method RADIUS attribute (Juniper Networks VSA 26-94) in RADIUS
Access-Accept messages.
Table 72 on page 404 describes the Tunnel-Tx-Speed-Method RADIUS attribute. For more
information about RADIUS Access-Accept messages, see "Configuring RADIUS Attributes"
on page 167. For a description of the RADIUS attributes supported by JunosE Software,
see "RADIUS IETF Attributes" on page 255.
Description
The method that the router
uses to calculate the transmit
connect speed of the
subscriber's access interface
Transmit Connect Speed Calculation Methods on page 398
Using AAA Domain Maps to Configure the Transmit Connect Speed Calculation Method
on page 401
Using AAA Tunnel Groups to Configure the Transmit Connect Speed Calculation Method
on page 402
Using AAA Default Tunnel Parameters to Configure the Transmit Connect Speed
Calculation Method on page 403
Using RADIUS to Configure the Transmit Connect Speed Calculation Method on page 404
aaa tunnel tx-connect-speed-method
Subtype
Length
Length
Value
12
6
integer:
1 = static-layer2; TX speed based
on static layer 2 settings
2 =dynamic-layer2; TX speed
based on dynamic layer 2
settings
3 = qos; TX speed based on QoS
settings
4 = actual; TX speed that is the
lesser of the dynamic-layer2
value or the qos value
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
