Outgoing Call; Table 78: Additions To Radius Attributes In Access-Accept Messages - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.

Table 78: Additions to RADIUS Attributes in Access-Accept Messages

Attribute Number Attribute Name
6 Service-Type
67 Tunnel-Server-Endpoint
Juniper VSA 26-35 Tunnel-Dialout-Number
Juniper VSA 26-36 PPP-Username
Juniper VSA 26-37 PPP-Password
Juniper VSA 26-38 PPP-Protocol
Juniper VSA 26-39 Tunnel-Min-Bps
Juniper VSA 26-40 Tunnel-Max-Bps
Juniper VSA 26-41 Tunnel-Bearer-Type

Outgoing Call

After receiving a valid tunnel definition from AAA, the E Series LNS initiates an outgoing
call. The router follows the same load-sharing mechanisms as for incoming calls. See
"Configuring LAC Tunnel Selection Parameters" on page 369.
After an outgoing call is successfully signaled, the router dynamically creates a PPP
interface. The profile in the dial-out route definition specifies any PPP configuration
options. Both the L2TP session and the PPP interface exist on a Service module, identical
to the LNS operation for incoming calls.
Once the PPP interface is created, Link Control Protocol (LCP) and IPCP are negotiated.
Chapter 14: Configuring L2TP Dial-Out
Content
Outbound
IP address of LAC
L2TP dial-out number
Username used in PPP L2TP dial-out
sessions at the LNS
Password used in PPP L2TP dial-out
sessions at the LNS
Authentication protocol used for L2TP
sessions.
0 = none
1 = PAP
2 = CHAP
3 = PAP-CHAP
4 = CHAP-PAP
Minimum line speed; passed to LAC (not
interpreted by the LNS)
Maximum line speed; passed to LAC (not
interpreted by the LNS)
Bearer capability required: 0=name;
1=analog; 2=digital. Passed to LAC (not
interpreted by the LNS).
415