[64] Tunnel-Type - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

radius ethernet-port-type
radius include nas-port-type
Related
Documentation
radius include tunnel-type
Copyright © 2010, Juniper Networks, Inc.
adsl-cap—Asymmetric DSL, carrierless amplitude phase (CAP) modulation
adsl-dmt—Asymmetric DSL, discrete multitone (DMT)
idsl—ISDN DSL
sdsl—Symmetric DSL
virtual—Virtual
xdsl—DSL of unknown type
Example
host1(config)#radius dsl-port-type xdsl
Use the no version to restore the default, xdsl.
See radius dsl-port-type
Use to set the NAS-Port-Type attribute for Ethernet interfaces to ethernet or virtual.
See radius ethernet-port-type
Example
host1(config)#radius ethernet-port-type virtual
Use the no version to restore the default, ethernet.
Use to include the NAS-Port-Type attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include nas-port-type acct-start enable
Use the no version to restore the default, enable.
Monitoring the DSL-Port-Type RADIUS Attribute on page 306

[64] Tunnel-Type

Use the following command to manage the Tunnel-Type RADIUS attribute.
radius include tunnel-type
Chapter 3: Configuring RADIUS Attributes
207