Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 68

JunosE 11.3.x Broadband Access Configuration Guide
key
logout subscribers
max-sessions
30
host1(config)#radius authentication server 10.10.0.1
host1(config-radius)#deadtime 10
Use the no version to set the time to the default value, 0
See deadtime
Use to configure secrets on the primary, secondary, and tertiary authentication servers.
The authentication or accounting server secret is a text string used by RADIUS to
encrypt the client and server authenticator field during exchanges between the router
and a RADIUS authentication server. The router encrypts PPP PAP passwords using
this text string.
The default is no server secret.
Example
host1(config)#radius authentication server 10.10.8.1
host1(config-radius)#key gismo
Use the no version to remove the secret.
NOTE: Authentication fails if no key is specified for the authentication
server.
See key
Use to issue an administrative reset to the user's connection to disconnect the user.
From Privileged Exec mode, you can log out all subscribers, or log out subscribers by
username, domain, virtual-router, port, or icr-partition.
This command applies to PPP users, as well as to non-PPP DHCP users.
Example
host1#logout subscribers username bmurphy
There is no no version.
See logout subscribers
Use to configure the number of outstanding requests supported by an authentication
or accounting server.
If the request limit is reached, the router sends the request to the next server.
Copyright © 2010, Juniper Networks, Inc.