Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 465

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Table 80: show aaa domain-map Output Fields (continued)
Field Name
override-password
Tunnel Tag
Tunnel Peer
Tunnel Source
Tunnel Type
Tunnel Medium
Tunnel Password
Tunnel Id
Tunnel Client Name
Tunnel Server Name
Tunnel Preference
Tunnel Max Sessions
Tunnel RWS
Tunnel Virtual Router
Tunnel Failover Resync
Field descriptions
Tunnel Switch Profile
Tunnel Tx Speed Method
show aaa domain-map
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Single password used for all users from a domain in
place of the values received from the remote client
Tag that identifies the tunnel
Destination address of the tunnel
Source address of the tunnel
L2TP
Type of medium for the tunnel; only IPv4 is supported
Password for the tunnel
ID of the tunnel
Host name that the LAC sends to the LNS when
communicating to the LNS about the tunnel
Host name expected from the peer (the LNS) when
during tunnel startup
Preference level for the tunnel
Maximum number of sessions allowed on a tunnel
L2TP receive window size (RWS) for a tunnel on the
LAC; displays either the configured value or the default
behavior, which is indicated by system chooses
Name of the virtual router to map to the user domain
name
L2TP peer resynchronization method
The actual fields displayed depend on your
configuration
Name of the L2TP tunnel switch profile
Method that the router uses to calculate the transmit
connect speed of the subscriber's access interface:
static layer2, dynamic layer2, qos, actual, not set
427