Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 727

ip http
ip http access-class
Copyright © 2010, Juniper Networks, Inc.
(Optional) Specify a standard IP access list that defines which subscribers can connect
3.
to the HTTP local server.
host1:west40(config)#ip http access-class chicagoList
(Optional) Specify the port on which the HTTP local server receives connection
4.
attempts.
host1:west40(config)#ipv6 http port 8080
NOTE: You can modify the port on which the HTTP local server receives
connection attempts. However, you must first disable the HTTP local
server and then modify the port.
(Optional) Specify the maximum number of connections that can exist between one
5.
IP address and the HTTP local server.
host1:west40(config)#ip http same-host-limit 20
Specify the maximum time that HTTP local servers maintain connections.
6.
host1:west40(config)#ip http max-connection-time 1000
Enable the HTTP local server to listen for and process IPv6 exception packets.
7.
host1:west40(config)#ipv6 http server
Configure the HTTP redirect feature for the IPv6 profile, interface or subinterface to
8.
be referenced in the guided entrance service definition.
host1:west40(config)#interface gigabitEthernet 6/0
host1:west40(config-if)#ipv6 http redirectUrl http://ispsite.redirect.com
HTTP Local Server Commands
This section describes the commands used to configure the HTTP local server application
for IPv4 and IPv6 on the E Series router.
Use to create the HTTP local server for IPv4.
Example
host1(config)#ip http
Use the no version to delete the HTTP local server.
See ip http
Use to allow only subscribers on the specified standard IP access list to connect to the
HTTP local server.
Example
host1(config)#ip http access-class chicagoList
Chapter 27: Configuring Service Manager
689