Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 63

aaa accounting default
Copyright © 2010, Juniper Networks, Inc.
Use to enable AAA broadcast accounting on a virtual router. Specifies that accounting
records be sent to the accounting servers on the virtual routers in the named virtual
router group.
A virtual router group can be used in any virtual router context, not just the context in
which it is created.
Example
host1(config)#virtual-router vrSouth25
host1:vrSouth25(config)#aaa accounting broadcast westVrGroup38
host1:vrSouth25(config)#exit
Use the no version to disable the AAA broadcast accounting.
See aaa accounting broadcast
Use to specify the accounting method used for a particular type of subscriber.
Specify one of the following types of subscribers:
atm1483; this keyword is not supported
tunnel
ppp
radius-relay
ipsec
ip (IP subscriber management interfaces)
NOTE: IP subscriber management interfaces are static or dynamic
interfaces that are created or managed by the JunosE Software's
subscriber management feature.
Although the atm1483 keyword is available in the CLI for this command,
that subscriber type is not supported. The router does not support
accounting for ATM 1483 subscribers.
Specify one of the following types of accounting methods:
radius—RADIUS accounting for the specified subscribers.
none—No accounting is done for the specified subscribers.
radius none—Multiple types of accounting; used in the order specified. For example,
radius none specifies that RADIUS accounting is initially used; however, if RADIUS
servers are not available, no accounting is done.
Example
host1(config)#aaa accounting ppp default radius
Chapter 1: Configuring Remote Access
25