JunosE 11.3.x Broadband Access Configuration Guide
radius include framed-ipv6-prefix
radius include framed-ipv6-route
214
Use the no version to restore the default, disable.
[97] Framed-Ipv6-Prefix
Use the following command to manage the Framed-Ipv6-Prefix RADIUS attribute.
radius include framed-ipv6-prefix
Use to include the Framed-Ipv6-Prefix attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the Framed-Ipv6-Prefix attribute by enabling or disabling
this command.
For RADIUS to include this attribute, at least one IPv6 prefix must be assigned to the
subscriber.
See radius include
Example
host1(config)#radius include framed-ipv6-prefix acct-start enable
Use the no version to restore the default, disable.
[99] Framed-Ipv6-Route
Use the following command to manage the Framed-Ipv6-Route RADIUS attribute.
radius include framed-ipv6-route
Use to include the Framed-Ipv6-Route attribute in Acct-Start or Acct-Stop messages.
You can control inclusion of the Framed-Ipv6-Route attribute by enabling or disabling
this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
When the Framed-Ipv6-Route attribute is not returned from the RADIUS server in the
Access-Accept message, the immediate accounting, Acct-Stop, or Interim-Acct
messages do not report this attribute.
See radius include
Example
host1(config)#radius include framed- ipv6-route acct-start enable
Use the no version to restore the default, disable.
[100] Framed-Ipv6-Pool
Use the following command to manage the Framed-Ipv6-Pool RADIUS attribute.
Copyright © 2010, Juniper Networks, Inc.