Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 239

radius override nas-info
radius remote-circuit-id-format
Copyright © 2010, Juniper Networks, Inc.
Example
host1(config)#radius include nas-identifier acct-start disable
Use the no version to restore the default, enable.
Use in the correct virtual router context to override the standard use of NAS-IP-Address
and NAS-Identifier attributes for AAA broadcast accounting; specifies that the attributes
for the authentication virtual router be included in accounting packets instead of the
attributes for the virtual router that generates the accounting information.
See radius override nas-info
Example
host1(config)#virtual-router vrXyz1
host1:vrXyz1(config)#radius override nas-info
Use the no version to restore the standard use of the NAS-IP-Address and
NAS-Identification attributes.
Use to configure the format of the PPPoE remote circuit ID value captured from a
DSLAM.
You can format the PPPoE remote circuit ID value to include either or both of the
agent-circuit-ID (suboption 1) and agent-remote-id (suboption 2) suboptions of the
DHCP relay agent information option (option 82) or the PPPoE intermediate agent
tags.
By default, the router formats the PPPoE remote circuit ID to include only the
agent-circuit-id suboption.
You can use this command to configure the following nondefault formats for the PPPoE
remote circuit ID value:
Include either or both of the agent-circuit-id and agent-remote-id suboptions, with
or without the NAS-Identifier [32] RADIUS attribute
Append the agent-circuit-id suboption value to an interface specifier that is consistent
with the recommended format in the DSL Forum Technical Report
(TR)-101—Migration to Ethernet-Based DSL Aggregation (April 2006).
For more information about how to use this command, see the Using the PPPoE Remote
Circuit ID to Identify Subscribers and Configuring PPPoE Remote Circuit ID Capture
sections in JunosE Link Layer Configuration Guide.
See radius remote-circuit-id-format
Examples
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
agent-remote-id
host1(config)#radius remote-circuit-id-format dsl-forum-1
Chapter 3: Configuring RADIUS Attributes
201