JunosE 11.3.x Broadband Access Configuration Guide
Meaning
436
Virtual router lns
Peer address 192.168.1.99
Destination profile maximum sessions is 5000
Statistics
Destination profile current session count is 2
Host profile attributes
Remote host is remhost22.xyz.com
Configuration
Tunnel password is 23erf5
Interface profile is ebcints
Bundled group id is 1
Bundled group id override is enabled
Maximum sessions is 400
Failover resync is failover-protocol
Statistics
Current session count is 14
Remote host is asciitext
Configuration
Bundled group id is 0
Tunnel password is 222
Interface profile is ascints
Default upper binding type mlppp
Maximum sessions is 250
Failover resync is failover-protocol
Statistics
Current session count is 2
Remote host is mexico
Configuration
Local ip address is 10.10.2.2
Proxy lcp is disabled
Proxy authenticate is enabled
mlppp upper binding type
Disconnect-cause avp is enabled
Receive window size is 4
Maximum sessions is 500
Failover resync is failover-protocol
Statistics
Current session count is 14
Remote host is LAC
Configuration
Tunnel password is TunnelPass
Local host name is LNS
Local ip address is 46.1.1.2
Disconnect-cause avp is enabled
Tunnels are single-shot
Override out-of-resource-result-code is enabled
Statistics
Current session count is 0
5 L2TP host profiles found
Table 86 on page 436 lists the show l2tp destination profile command output fields.
Table 86: show l2tp destination profile Output Fields
Field Name
Destination profile attributes
Transport
Field Description
Destination profile attributes of L2TP destination
Method used to transfer traffic
Copyright © 2010, Juniper Networks, Inc.