Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 241

radius include acct-session-id
radius acct-session-id-format
Copyright © 2010, Juniper Networks, Inc.
NOTE: The Acct-Session-Id VSA is used:
In the RADIUS-initiated change-of-authorization (CoA) message to start
the mirroring session when the user is already logged in
As a trigger in user-initiated mirroring to identify the user whose traffic is
to be mirrored
This VSA can be optionally included in the CoA message from the RADIUS
server or in the user login request if the packet mirroring operation is required.
Use to include the Acct-Session-Id attribute in Access-Request, Acct-On, or Acct-Off
messages.
You can control inclusion of the Acct-Session-Id attribute by enabling or disabling this
command.
See radius include
Example
host1(config)#radius include acct-session-id access-request disable
Use the no version to restore the default, enable.
Use to set the Acct-Session-Id attribute format. Two formats are supported:
description—Configures RADIUS client to use the generic format: erx <interface
identifier>:<hex number>. For example: erx atm 12/1:0.3:0000ef1
NOTE: For subscribes connected over the LAG interface in DHCP
standalone authenticate mode, the LAG interface ID is used as the
interface identifier. For more information about subscribers connected
over the LAG interface in DHCP standalone authenticate mode, see
"Propagation of LAG Subscriber Information to AAA and RADIUS" on
page 90.
decimal—Configures the RADIUS client to use a decimal format. For example: 435264
See radius acct-session-id-format
Example
host1(config)#radius acct-session-id-format decimal
Use the no version to negate the Acct-Session-Id format.
Chapter 3: Configuring RADIUS Attributes
203