JunosE 11.3.x Broadband Access Configuration Guide
Including or Excluding Attributes in RADIUS Messages
radius include
Related
Documentation
Ignoring Attributes When Receiving Access-Accept Messages
radius ignore
234
Use to include the set of DSL Forum VSAs in Access-Request, Acct-Start, and Acct-Stop
messages that the router sends to RADIUS. If you enable inclusion of the DSL Forum
VSAs in Acct-Stop messages, the router also includes the VSAs in Interim-Acct
messages.
You can control inclusion of the DSL Forum VSAs in the specified message type by
enabling or disabling this command. Inclusion is disabled by default.
When you enable inclusion of the DSL Forum VSAs for a specified message type, the
router includes in that message all of the DSL Forum attributes that it receives from
the DSLAM.
Example
host1(config)#radius include dsl-forum-attributes access-request enable
Use the no version to restore the default behavior, disable.
See radius include dsl-forum-attributes
For many attributes, you can configure the router to include or exclude the attribute in
RADIUS messages.
Use to enable or disable the inclusion of RADIUS attributes in Acct-On, Acct-Off,
Access-Request, Acct-Start, and Acct-Stop messages.
Examples
host1(config)#radius include ingress-policy-name acct-start enable
host1(config)#radius include tunnel-type access-request disable
Use the no version to restore the default, disable.
See radius include
To see a list of the attributes that you can include or exclude, see Monitoring Included
RADIUS Attributes on page 307
You can configure the router to ignore or use many attributes that it receives in
Access-Accept messages.
Use to specify that a RADIUS attribute be ignored or be accepted from Access-Accept
messages.
Use the enable keyword to specify that the RADIUS client ignore the attribute from
the RADIUS server or the disable keyword to use the attribute.
Examples
Copyright © 2010, Juniper Networks, Inc.