Multiple Clients per ATM Subinterface
Copyright © 2010, Juniper Networks, Inc.
Configure an ATM interface by entering Configuration mode and performing the following
tasks. For more information about configuring ATM interfaces, see JunosE Link Layer
Configuration Guide.
Configure a physical interface.
1.
host1(config)#interface atm 0/1
Configure the subinterface.
2.
host1(config-if)#interface atm 0/1.20
Configure a permanent virtual circuit (PVC) by specifying the vcd (virtual circuit
3.
descriptor), the vci (virtual channel identifier), the vpi (virtual path identifier), and
the encapsulation type.
host1(config-if)#atm pvc 10 22 100 aal5snap
Configure PPP encapsulation.
4.
host1(config-if)#encapsulation ppp
Configure PAP or CHAP authentication.
5.
host1((config-if))#ppp authentication chap
Assign a profile to the PPP interface.
6.
host1(config-subif)#profile foo
Figure 4 on page 59 shows how PPPoE supports multiplexing of multiple PPP sessions
per ATM subinterface.
Figure 4: Multiple PPP Clients per ATM Subinterface
Configure an ATM interface by entering Configuration mode and performing the following
tasks. For more information about configuring ATM interfaces, see JunosE Link Layer
Configuration Guide.
Configure a physical interface.
1.
host1(config)#interface atm 0/1
Configure the subinterface.
2.
host1(config-if)#interface atm 0/1.20
Chapter 1: Configuring Remote Access
59