[32] Nas-Identifier - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
radius override calling-station-id remote-circuit-id
Related
Documentation
radius nas-identifier
radius include nas-identifier
200
Example
host1(config)#radius include calling-station-id acct-start disable
Use the no version to restore the default, enable.
Use to configure RADIUS to override the standard use of the Calling-Station-Id attribute
and instead use the remote circuit ID transmitted from a DSLAM device.
See radius override calling-station-id remote-circuit-id
Example
host1(config)#radius override calling-station-id remote-circuit-id
Use the no version to restore the default Calling-Station-ID value, which is the telephone
number from which the call originated.
Monitoring Override Settings of RADIUS IETF Attributes on page 303
Monitoring the Calling-Station-Id RADIUS Attribute on page 305

[32] NAS-Identifier

Use the following commands to manage and display information for the NAS-Identifier
RADIUS attribute.
radius nas-identifier
radius include nas-identifier
radius override nas-info
radius remote-circuit-id-format
radius remote-circuit-id-delimiter
Use to set a value for the NAS-Identifier attribute. This value is used in the NAS-Identifier
attribute for authentication and accounting requests.
Example
host1(config)#radius nas-identifier fox
Use the no version to delete the NAS-Identifier.
See radius nas-identifier
Use to include the NAS-Identifier attribute in Access-Request, Acct-Start, Acct-Stop,
Acct-On, and Acct-Off messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Copyright © 2010, Juniper Networks, Inc.