Setting A Baseline For Radius Relay Statistics; Monitoring Radius Relay Server Statistics; Table 60: Show Radius Dynamic-Request Servers Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
Meaning
Related
Documentation

Setting a Baseline for RADIUS Relay Statistics

Related
Documentation

Monitoring RADIUS Relay Server Statistics

Purpose
Action
312
Table 60 on page 312 lists the show radius dynamic-request servers command output
fields.

Table 60: show radius dynamic-request servers Output Fields

Field Name
IP address
Udp Port
Disconnect
Change of Authorization
Secret
show radius servers
You can set a baseline for RADIUS relay statistics. To show baseline statistics, use the
delta keyword with the show radius relay command.
To set a baseline for RADIUS relay statistics:
Issue the baseline radius relay command:
host1#baseline radius relay
There is no no version.
Monitoring RADIUS Relay Server Statistics on page 312
baseline radius relay
Display RADIUS relay server statistics.
To show RADIUS relay server statistics that were baselined:
host1#show radius relay statistics delta
RADIUS Relay Authentication Server Statistics
---------------------------------------------
Statistic Total
------------------ -----
Access Requests 1000
Access Accepts 1000
Access Challenges 0
Access Rejects 0
Pending Requests 0
Field Description
IP address of the RADIUS server
Port on which the router listens for RADIUS server
Status of RADIUS-initiated disconnect feature
Status of change of authorization feature
Secret used to connect to RADIUS server
Copyright © 2010, Juniper Networks, Inc.