Cli Aaa Messages; Table 43: Cli Aaa Access Message Radius Attributes Supported - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Table 42: DSL Forum (Vendor ID 3561) VSAs Supported in AAA Access
and Accounting Messages (continued)
Attribute
Number Attribute Name
[26-132] Minimum-Data-Rate-Downstream
[26-133] Attainable-Data-Rate-Upstream
[26-134] Attainable-Data-Rate-Downstream
[26-135] Maximum-Data-Rate-Upstream
[26-136] Maximum-Data-Rate-Downstream
[26-137] Minimum-Data-Rate-Upstream-Low-Power
[26-138] Minimum-Data-Rate-Downstream-Low-Power
[26-139] Maximum-Interleaving-Delay-Upstream
[26-140] Actual-Interleaving-Delay-Upstream
[26-141] Maximum-Interleaving-Delay-Downstream
[26-142] Actual-Interleaving-Delay-Downstream
[26-144] Access-Loop-Encapsulation
[26-254] IWF-Session

CLI AAA Messages

There are four types of AAA messages used by CLI users to gain administrative access
to the router. Access-Challenge attributes pertain only to CLI/telnet users.
Table 43 on page 187 lists the RADIUS attributes supported for CLI AAA messages.

Table 43: CLI AAA Access Message RADIUS Attributes Supported

Attribute
Number Attribute Name
[1] User-Name
Copyright © 2010, Juniper Networks, Inc.
Access-Request
Access-Accept
Access-Challenge
Access-Reject
Access-Request
Chapter 3: Configuring RADIUS Attributes
Access-Request Acct-Start
Access-Accept Access-Challenge
– –
Acct-Stop Interim-Acct CoA-Request
–
–
–
–
–
–
–
–
–
–
–
–
–
Access-Reject
–
187