Configuring Service Manager; Service Manager Overview - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

CHAPTER 27

Configuring Service Manager

Service Manager Overview

Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to use the Service Manager application to define, activate,
and monitor networking services for your subscribers. This chapter discusses the following
topics:
Service Manager Overview on page 633
Service Manager Platform Considerations on page 635
Service Manager References on page 635
Service Manager Configuration Tasks on page 635
Service Definitions on page 637
Referencing Policies in Service Definitions on page 642
Referencing QoS Configurations in Service Definitions on page 642
Configuring the Service Manager License on page 650
Managing and Activating Service Sessions on page 651
Using RADIUS to Manage Subscriber Service Sessions on page 652
Using Mutex Groups to Activate and Deactivate Subscriber Services on page 658
Combined and Independent IPv4 and IPv6 Services in a Dual Stack Overview on page 660
Activation and Deactivation of IPv4 and IPv6 Services in a Dual Stack on page 662
Configuring RADIUS Accounting for Service Manager on page 663
Using the CLI to Manage Subscriber Service Sessions on page 669
Configuring Service Manager Statistics on page 677
Service Manager Performance Considerations on page 681
Service Definition Examples on page 682
The JunosE Service Manager application provides authentication, service selection, and
service activation and deactivation to subscribers. The application also collects accounting
information and statistics, and monitors subscriber and service sessions.
Service Manager supports two client types—RADIUS and CLI. Service Manager starts
when it receives a request from a RADIUS or CLI client. For RADIUS clients, RADIUS
Access-Accept messages and Change-of-Authorization-Request (CoA-Request)
633