Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual page 309

Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Attribute
Number Attribute Name
[26-126] Act-Interlv-Delay-Dn
[26-127] DSL-Line-State
[26-128] DSL-Type
[26-129] Ipv6-NdRa-Prefix
[26-130] QoS-Interfaceset-Name
[26-140] Service-Interim-Acct-
Interval
[26-141] Downstream-Calculated-
Qos-Rate
[26-142] Upstream-Calculated-
Qos-Rate
[26-143] Max-Clients-Per-Interface
[26-144] PPP-Monitor-Ingress-
Only
Copyright © 2010, Juniper Networks, Inc.
Description
Subscriber's actual one-way downstream
interleaving delay
State of the DSL line
Encapsulation used by the subscriber
associated with the DSLAM interface from
which requests are initiated
Prefix value in IPv6 Neighbor Discovery
route advertisements
Name of the QoS interface set to attach to
the subscriber interface
Amount of time between interim
accounting updates for this service.
Calculated downstream QoS rate in Kbps
as set by the ANCP configuration
Calculated downstream QoS rate in Kbps
as set by the ANCP configuration
Maximum number of PPPoE client sessions
supported per interface. For DHCP clients,
this value is the maximum number of
PPPoE sessions per logical interface. For
PPPoE, this value is the maximum number
of PPPoE subinterfaces per a PPPoE major
interface.
See JunosE Release Notes, Appendix A,
System Maximums corresponding to your
software release for information about the
maximum number of PPPoE subinterfaces
supported for each line module.
Enable or disable monitoring of only ingress
traffic to determine inactivity of a PPP
session and subsequent disconnection of
an inactive session. If this option is disabled
or not configured, the router monitors both
ingress traffic and egress traffic to
determine session inactivity.
Chapter 6: RADIUS Attribute Descriptions
Subtype
Length Length Value
12 6 integer: 4-octet
12 6 4-octet integer
1 = Show uptime
2 = Idle
3 = Silent
11 5 string: 3-byte
len sublen hexadecimal string
len sublen string:
qos-interfaceset-name
12 6 integer: time in the
range 600–86400
seconds;
0 = disabled
12 6 integer: 4-octet
12 6 integer: 4-octet
12 6 integer: 4-octet
12 6 integer:
0 = disable,
1 = enable
271