[90] Tunnel-Client-Auth-Id - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
aaa intf-desc-format include
radius include nas-port-id
radius override nas-port-id remote-circuit-id
Related
Documentation
radius include tunnel-client-auth-id
212
Use to specify whether the router includes the subinterface number or adapter in the
interface description it passes to RADIUS for inclusion in the NAS-Port-Id attribute. By
default, the subinterface and adapter are sent (the commands are enabled).
Examples
host1#aaa intf-desc-format include sub-intf disable
host1#aaa intf-desc-format include adapter enable
Use the no version to remove the configuration.
See aaa intf-desc-format include
Use to include the NAS-Port-Id attribute in the Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the NAS-Port-Id attribute by enabling or disabling this
command.
See radius include
Example
host1(config)#radius include nas-port-id access-request enable
Use the no version to restore the default, enable.
Use to configure RADIUS to override the standard use of the NAS-Port-Id attribute
and instead use the remote circuit ID transmitted from a DSLAM device.
See radius override nas-port-id remote-circuit-id
Example
host1(config)#radius override nas-port-id remote-circuit-id
Use the no version to restore the default NAS-Port-ID value, which is the physical
interface of the NAS that is authenticating the user.
Monitoring Override Settings of RADIUS IETF Attributes on page 303
Monitoring the NAS-Port-ID RADIUS Attribute on page 307

[90] Tunnel-Client-Auth-Id

Use the following command to manage the Tunnel-Client-Auth-Id RADIUS attribute.
radius include tunnel-client-auth-id
Copyright © 2010, Juniper Networks, Inc.