Subscriber Aaa Accounting Messages - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Table 38: AAA Access Message Juniper Networks (Vendor ID 4874) VSAs Supported (continued)
Attribute
Number Attribute Name
[26-120] Max-Data-Rate-Dn
[26-121] Min-LP-Data-Rate-Up
[26-122] Min-LP-Data-Rate-Dn
[26-123] Max-Interlv-Delay-Up
[26-124] Act-Interlv-Delay-Up
[26-125] Max-Interlv-Delay-Dn
[26-126] Act-Interlv-Delay-Dn
[26-127] DSL-Line-State
[26-128] DSL-Type
[26-129] Ipv6-NdRa-Prefix
[26-130] QoS-Interfaceset-Name
[26-140] Service-Interim-Acct-Interval
[26-141] Downstream-Calculated-Qos-
Rate
[26-142] Upstream-Calculated-Qos-Rate
[26-143] Max-Clients-Per-Interface
[26-144] PPP-Monitor-Ingress-Only
[26-147] Backup-Address-Pool
[26-150] ICR-Partition-Id
[26-159] DHCP-Option 82

Subscriber AAA Accounting Messages

Copyright © 2010, Juniper Networks, Inc.
Access-
Request
–
–
–
–
—
—
Accounting messages identify service provisions and use on a per-user or per-tunnel
basis. These messages keep track of when a particular service is initiated and terminated
for a specific user.
Chapter 3: Configuring RADIUS Attributes
Access- Access-
Accept Reject
– –
– –
– –
– –
– –
– –
– –
– –
– –
–
–
–
–
–
–
—
—
— —
— —
CoA- Disconnect-
Request Request
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
–
–
–
– –
— —
— —
— —
—
177