Configuring A B-Ras License - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

Configuring a B-RAS License

license b-ras
Copyright © 2010, Juniper Networks, Inc.
Configure an authentication server on the router.
5.
(Optional) Configure UDP checksums.
6.
(Optional) Configure an accounting server on the router.
7.
(Optional) Configure Domain Name System (DNS) and Windows Internet Name
8.
Service (WINS) name server addresses.
(Optional) Configure a local address pool for remote clients.
9.
(Optional) Configure one or more DHCP servers.
10.
Create a PPP interface on which the router can dynamically create an IP interface.
11.
(Optional) Configure AAA profiles.
12.
(Optional) Use vendor-specific attributes (VSAs) for Dynamic Interfaces.
13.
(Optional) Set idle or session timeout.
14.
(Optional) Limit the number of active subscribers on a virtual router (VR) or port.
15.
(Optional) Set up the router to notify RADIUS when a user fails AAA.
16.
(Optional) Configure a RADIUS download server on the router.
17.
(Optional) Configure the Session and Resource Control (SRC) client (formerly the
18.
SDX client).
(Optional) Set baselines for AAA statistics or RADIUS authentication and accounting
19.
statistics.
From Global Configuration mode, configure a B-RAS license:
host1(config)#license b-ras k3n91s6gvtj
B-RAS licenses are available in various sizes to enable subscriber access for up to one
of the following maximum number of simultaneous active IP, LAC, and bridged Ethernet
interfaces:
4000
8000
16,000
32,000
48,000
NOTE: To use a B-RAS license for 16,000 or more interfaces, each of your
SRP modules must have 1 gigabyte (GB) of memory.
Chapter 1: Configuring Remote Access
7